shear strength
英 [ʃɪə(r) streŋθ]
美 [ʃɪr streŋθ]
网络 剪切强度; 抗剪强度; 抗剪強度; 剪力; 切变强度
双语例句
- Testing methods for impact shear strength of and tensile strength of adhesives
GB/T6328-1986胶粘剂剪切冲击强度和拉伸强度试验方法 - Embedded columns can increase shear strength as well as control of displacement and failure.
配以暗框边柱能提高剪力墙的抗剪强度、位移控制和破坏控制能力。 - The relationship between shear strength and water content of Hefei expansive soil was studied with two different experimental methods.
通过试验研究了合肥膨胀土抗剪强度随含水量变化的关系。 - Tensile strength and lap shear strength increased with increasing of grafting degree due to great improvement of polarity.
离聚体的拉伸强度、搭接剪切强度和乳化性能均随顺酐化程度的提高而改善。 - The stability of jointed rock slope is controlled by the shear strength of joints and rock block simultaneously.
节理岩体边坡失稳破坏同时受控于节理与岩体抗剪强度。 - Indirect methods to measure the interface bond strength include the interlaminar shear strength test.
测量界面粘结强度的间接方法包括层间剪切强度试验。 - Research on effects of suction, water content and dry density on shear strength of remolded unsaturated soils
吸力、含水率和干密度对重塑非饱和土抗剪强度影响研究 - Two similar properties are compressive strength and shear strength, related to compressive forces and shear forces respectively.
两个类似的性能分别是与压缩力和剪切力有关的压缩强度和剪切强度。 - It was found that the adhesive tensile and shear strength of the modified epoxy resin was increased.
实验表明：预聚体的加入明显提高了环氧树脂的粘接剪切强度和拉伸强度。 - Ambitious attempts to improve interlaminar shear strength have been made by Mueller Prosen and by Keogh.
米勒·普罗森还有基奥都对提高层间切变强度作了大胆的尝试。 - Moreover, the statistical methods of shear strength of soils are summarized.
对土的抗剪强度指标的统计方法进行了总结。 - Influences of the metallizing technologic conditions, Ni plating and subsequent annealing on the joint shear strength were investigated.
考察了金属化工艺、镀镍及镀后热处理对接头剪切强度和钎焊效果的影响。 - I find that when tree species is different, dry and wet compression shear strength is different obviously.
对不同树种的干、湿压缩剪切强度进行了研究。 - When the density is same, the higher the confining pressure, the higher the shear strength.
密度相同时，围压越高，粗粒土的抗剪强度也越高； - The research results indicate that the temperature has complicated influence on the shear strength of clayey soil.
试验结果表明：温度对粘性土的抗剪强度有比较复杂的影响。 - The shear strength increases with the increasing first-order and second-order asperity heights and normal stress.
节理剪切强度随着一阶和二阶起伏度及法向应力的增大而增大； - The same parameters of effective shear strength were obtained form the axial compression and the lateral extension tests.
轴向加荷和侧向卸荷条件下得到的有效抗剪强度指标基本一致。 - A simple analytical model is presented to predict the ultimate punching shear strength of square steel fiber concrete slab.
该文基于统一强度理论对钢纤维混凝土方形板的冲切承载力进行了理论分析，推导了冲切破坏强度的计算公式。 - Based on the shear strength reduction FEM, deformation behavior of subgrade embankments on inclined weak foundation is studied.
基于强度折减有限元法，对倾斜软弱地基填方工程的基本特征进行了考察。 - The introduction to the testing method for tensile and shear strength of high strength photosensitive glue is given and the main causes that have influence on the testing result are analyzed.
摘要介绍了一种高强度光敏胶拉伸剪切强度测试方法，分析了影响测试结果的几种主要因素。 - The morphology of joint surface is one of the key factors affecting shear strength of joint.
节理表面形貌是影响节理抗剪强度的重要因素之一。 - Numerical analysis for shear strength and deformation characteristic of joint plane with complicated surface
复杂节理面剪切强度和变形特征的数值分析 - It focuses on the influence of different shear strength on the calculation of earth pressure.
着重讨论了选取不同抗剪强度参数时对土压力计算的影响。 - The effects of rolling and annealing temperatures on the shear strength of titanium cladding steel plate were investigated.
研究轧制温度、退火温度对复合板剪切强度的影响。 - The deformation and shear strength of lateritic clay are studied by compaction tests and shear tests.
通过击实试验和击实后土样的压缩和剪切试验研究红黏土的变形和强度特性。 - Through experiments, the shear strength of concrete hollow brick masonry has been researched in this paper.
通过试验研究了混凝土（空心）砖砌体的抗剪强度。 - A shear strength formula of Ningming unsaturated expansive soil is put forward as result of regressing the testing result.
并对试验结果进行了数值拟和，由此获得了宁明膨胀土非饱和抗剪强度表达式。 - The single fiber fragmentation test has been used to determine the interfacial shear strength of composite materials.
单纤维段裂试验作为复合材料界面剪切强度的一种测试方法被沿用至今。 - The shear strength and elongation of the lap joint increase with the increase of strain rate.
焊点的剪切强度及伸长量随应变速率的增加而增加。